Revolutionary new patented gutter system available only from Seamless Aluminium Ltd.
Developed at the company's Ballyshannon plant, the new SLIP system has been designed and patented for simple installation by both professionals and DIY enthusiasts.
1.
The top half is a contoured protective hood that draws water by the principle of water adhesion around its curved surface through the opening between the
2.
two sections and then deposits the water in the gutter.
3.
At the same time the gap is too narrow to allow leaves or debris to get through,
4.
so ensuring a free flowing gutter system.
Dimensions
Top Gutter Section (63,63 x 130 mm)
Bottom Gutter Section 118,32 x 135 mm)
Mitres
(200 x 200 mm)
(200 x 200 mm)
I/S & O/S Box Mitre (90°)
I/S & O/S Angle Mitre (135°)
Other angles are available on request
Slip Gutter Outlets
(200 mm)
Gutter outlets can be made to suit the pipe being used, whether it be a different size 63.5 (2.5"), 76.2 (3.0"), 101.6 (4.0") or shape (round / square)
The bottom gutter section is put up first by a direct fix method. It is attached to the fascia with screws. The top gutter section can now be slotted into place and secured with screws.
The grooves on the back wall act as a guide for correct positioning of the screws. On a 3m length of gutter, the screws are placed at 450mm centres. This is the same for both top and bottom gutter sections.
The gutter (and its other components) are joined together with a 50mm internal connector. The gutter joint is sealed by applying a single sided.
